Siemens SINAMICS V20 Inverter, Руководство по эксплуатации

Страница: 300 / 426

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
298
Operating Instructions, 10/2019, A5E34559884-012
Parameter Function Range Factory
default
Can be
changed
Scaling Data
set
Data
type
Acc.
Level
Note: See P2201
P2216[0...2] Fixed PID setpoint mode 1 - 2 1 T - DDS U16 2
Fixed frequencies for PID setpoint can be selected in two different modes. P2216 defines the mode.
1 Direct selection
2 Binary selection
P2220[0...2] BI: Fixed PID setpoint
select bit 0
0 - 4294967295 722.3 T - CDS U32 3
Defines command source of fixed PID setpoint selection bit 0.
P2221[0...2] BI: Fixed PID setpoint
select bit 1
0 - 4294967295 722.4 T - CDS U32 3
Defines command source of fixed PID setpoint selection bit 1.
P2222[0...2] BI: Fixed PID setpoint
select bit 2
0 - 4294967295 722.5 T - CDS U32 3
Defines command source of fixed PID setpoint selection bit 2.
P2223[0...2] BI: Fixed PID setpoint
select bit 3
0 - 4294967295 722.6 T - CDS U32 3
Defines command source of fixed PID setpoint selection bit 3.
r2224 CO: Actual fixed PID
setpoint [%]
- - - - - Float 2
Displays total output of PID fixed setpoint selection.
Note: r2224 = 100 % corresponds to 4000 hex.
r2225.0 BO: PID fixed frequency
status
- - - - - U16 3
Displays the status of PID fixed frequencies.
Bit Signal name 1 signal 0 signal
00 Status of FF Yes No
P2231[0...2] PID-MOP mode 0 - 3 0 U, T - DDS U16 2
PID-MOP mode specification
Bit Signal name 1 signal 0 signal
00 Setpoint store active Yes No
01 No On-state for MOP necessary Yes No
Note: Defines the operation mode of the motorized potentiometer. See P2240.
P2232 Inhibit reverse direction of
PID-MOP
0 - 1 1 T - - U16 2
Inhibits reverse setpoint selection of the PID-MOP.
0 Reverse direction is allowed
1 Reverse direction inhibited
Note: Setting 0 enables a change of motor direction using the motor potentiometer setpoint (increase/decrease
frequency).
P2235[0...2] BI: Enable PID-MOP (UP-
cmd)
0 - 4294967295 0 T - CDS U32 3
Defines source of UP command.