Installation Instructions PG-5412/MS-DOS, Windows
Installation Instructions PG-5412/MS-DOS, Windows
29
S79200-A0735-X-03-7419
1 Software
Requirements
1.1
General Software Requirements
Operating System
The PG-5412/MS-DOS, Windows software can only be run under
Microsoft DOS 6.x and Microsoft Windows 3.11.
CP 5412 (A2)
You require a CP 5412 (A2) SIMATIC NET communications processor
for operation. Before plugging in the CP 5412 (A2) module please set
the DIP switch to the I/O range proposed by the installation program. If
you are installing several modules, make sure that a different I/O range
is set on each CP.
I/O Range
Each CP 5412 (A2) occupies four continuous addresses in the I/O
address area starting at a selectable base address. The following base
addresses (hex) are available:
240, 244, 248, 24C,
280, 284, 288, 28C,
300, 304, 308, 30C,
390, 394, 398, 39C.
How to set the address (with a DIL switch) is described in Chapter 5,
„Appendix - Installation Instructions for the CP 5412 (A2)“.
Please make sure that the I/O range you have selected is not used for
any other purpose in your system.
Interrupt
Each CP 5412 (A2) requires one interrupt for operation. This can be
set in the software. Make sure that one of the following interrupts on
your system is free for the CP 5412 (A2):
IRQ 5, IRQ 10, IRQ 11, IRQ 12, IRQ 15
You should also make sure that the interrupt you selected is not being
used already by other components in your system.
