Installationsanleitung PG-5412/MS-DOS, Windows
Installationsanleitung PG-5412/MS-DOS, Windows
13
S79200-A0735-X-03-7419
2.4 Konfiguration
Konfiguration der
Software
Damit die installierte Software den CP 5412 (A2) ansprechen kann,
müssen Sie den CP 5412 (A2) konfigurieren. Starten Sie hierzu
SINEC-Setup (siehe Kapitel 3) und gehen Sie wie folgt vor:
Wählen Sie in der Hardware-Auswahlliste (untere Auswahlliste) einen
Eintrag für den CP-Typ „CP 5412 (A2)“ aus.
Rufen Sie über den Menüpunkt „Bearbeiten/Konfiguration ändern“ das
Konfigurationsprogramm auf.
Nehmen Sie die notwendigen Einstellungen vor. Beachten Sie dabei
die Hinweise der Abschnitte E/A-Bereich, Interrupt und Dual-Port-RAM-
Adreßbereich des Kapitels 1.
Speichern Sie Ihre Konfiguration ab und beenden Sie das Konfigurati-
onsprogramm.
Beenden Sie SINEC-Setup.
Starten des
Treibers
Bei jedem Wiederanlauf des Rechners werden die von Ihnen aktivier-
ten Protokolle automatisch gestartet.
Hierzu trägt das Installationsprogramm in der Datei AUTOEXEC.BAT
folgenden Aufruf ein, falls dieser Aufruf nicht bereits in der Datei vor-
kommt:
call x:\sinec\sinecini.bat
Das Konfigurationsprogramm ergänzt den Initialisierungs-Batch
„x:\sinec\sinecini.bat“ um einen Aufruf für den Start des CP 5412 (A2)
mit den von Ihnen gewählten Protokollen.
Der Buchstabe x steht dabei für das Laufwerk, auf dem Sie das Pro-
dukt PG-5412/MS-DOS, Windows installiert haben.
Das Konfigurationsprogramm gibt als Voreinstellung des Device-
Namens die Kennung CP_L2_x: vor; „x“ ist die Nummer des
CPs = 1, 2, ...
Bei Verwendung der DP-Programmierschnittstelle darf diese Vor-
einstellung nicht geändert werden, da die DP-Libraries standard-
mäßig diese Kennung verwenden.
CP_L2_x ist dem CP 5412 (A2) (PROFIBUS) zuzuordnen.
Weitere Hinweise zur Konfiguration entnehmen Sie bitte der Hilfefunk-
tion des aufgerufenen Konfigurationsprogramms.
☞
✓
✓
✓
✓
✓