SIEB & MEYER sinudyn-0360520 Series, Описание аппаратуры

Страница: 9 / 95

Safety Instructions and Application Advice
:
8 Safety Instructions/Application Advice
2.2 Appropriate Use
Definition of the concepts acc. to DIN / EN 61800 - 3.
Before initial operation, make sure that the machine will not expose danger (e.g. un-
controlled moves). The conformity according to the safety standard EN 60204-1 and
EN 61800-5-1 must have been proven.
The manufacturer of the system or the machine has to meet the requirements of the
legal values regarding the Electromagnetic Compatibility (EMC). SIEB & MEYER
units can be operated in industrial areas, provided that the attached EMC information
has been taken into consideration.
SIEB & MEYER takes care in its own EMC laboratory over their products to meet the
respective standards, when they are installed properly.
Deviations of the construction and the installation, described in the documentation
and in the manual "Unit Assembly Complying EMC" require new measurements of
the system or machine by the machine manufacturer to meet the statutory require-
ments.
Appropriate proceedings according to the EMC Product Standard (PDS) DIN/EN 61
800-3 ensure the use in industrial areas.
X Products, not equipped with an AC supply line filter must be operated with a se-
ries connected mains filter! Detailed information can be found in the chapter
"Unit Assembly Complying EMC".
If using the drive systems in residential areas, in business and commercial areas as
well as in small trade, the user has to take additional and larger filter measurements.
All SIEB & MEYER products meet the requirements of the Low-Voltage Directive
2006/95/EC . The coordinated standards of the series IEC / EN 50178 and IEC / EN
60 204-1 in combination with IEC / EN 60 947 and IEC / EN 61800-5-1 are strictly
used for the products.
Technical data and the connection specification can be found in the respective prod-
uct documents.
2.3 Transport and Storage
Make sure, that the unit is correctly used. The following points must especially be tak-
en into consideration:
X Protection against mechanical damage (transport, handling, etc.)!
X Protection against dirt and humidity!
X Dry and well-ventilated storage area!
X No storage in the open!
X Storage temperature between -25°C to +55°C (-13°F to +131°F)! Shortly it may
be +70°C (+158°F).
X Protection against contact with electronic components (electrostatic discharge)!
X No modification of insulating distances!
2.4 Installation
The drive components are designed for fulfilling the degree of pollution 2 according
to IEC 61800-1 / DIN EN 50178.