SIEB & MEYER sinudyn-0360520 Series, Описание аппаратуры

Страница: 11 / 95

Safety Instructions and Application Advice
:
10 Safety Instructions/Application Advice
X Capacitive loads must not be connected to the output phases of the servo am-
plifiers and frequency converters.
X Prevent cable loops. Therefore, the units must only be connected to earth at the
provided PE connection for the mains supply line and the racks only at the pro-
vided earth screw.
In general, the operation can be made with residual current operated devices. Nev-
ertheless, like all clocked units of the power electronics, also SIEB & MEYER prod-
ucts can lead leakage currents via the earth system. Depending on the sensitivity of
the residual current operated device and the installation type, the operation along
with the device may arise problems. The following points should be taken into con-
sideration:
X Use the shortest connection and motor cables possible.
X Do not connect additional consumers to the same residual current operated de-
vice.
X Use residual current operated devices with high response threshold and time-
lag response time.
2.6 Operation
Systems, into which servo amplifiers and frequency converters are mounted, possi-
bly must be equipped with additional protective devices according to the valid safety
instructions (e.g. law about technical material, rules for prevention of accidents, etc.).
All doors and covers must be closed during the operation.
2.7 Maintenance
The unit, especially the fan, must be checked regularly for cleanness and function
depending on the ambient pollution.
2.8 Disposal
X SIEB & MEYER products fulfill the requirements covered in the Directive 2002/
95/EC on the restriction of the use of hazardous substances in electrical and
electronic equipment (RoHS Directive)
Make sure that the country-specific waste and disposal laws and statutes are con-
sidered for the disposal of packing material and irreparable devices.
Warning
To ensure a trouble-free operation of the installation, the fixing
screws of all front panels device parts must always be tightened!