40
ENGLISH • Instructions manual
S 45 TL
S 45 TL
14. MOVING THE MACHINE
Follow the procedures outlined below when moving the machine:
1)
Close the turntable grippers all the way towards the centre.
2)
Turn the table so that the its straight sides are lined up the projected line of the side
panels (
See Fig. Z/1
).
3)
Disconnect all power sources.
4)
Clamp the pedal (
7, Fig. D
) with a wedge underneath it.
5)
Remove the horizontal arm casing by unscrewing the fixing nuts (
1, Fig. Z/2
).
6)
Move the horizontal arm (
11, Fig. D
) all the way back.
7)
Sling the machine with lifting straps at least 60 mm wide.
8)
Pass the first strap behind the horizontal arm as shown in
Fig. Z/3
.
9)
Pass the second strap between the two front slots on the turntable plate as shown in
Fig. Z/1
.
10)
Gather the ends of the slings in a suitable ring above the machine.
11)
Hoist and move the machine with a sufficiently strong lift truck.
Z/1
1
Z/2
Z/3
13. FIRE-FIGHTING
Lubricate these slides using
ISO VG 68
viscosity
ISO HG
class grease (such as, for example
ESSO Febis K68; Mobil Vactra 2; Shell
Tonna Oil 68
).
4)
To ensure correct operation of the inflation device pressure limiter (Refer to the section on “SAFETY DEVICES”, p. 27 of this manual,
it is
essential
to carry out the following routine
checks
:
- Check the water level in the water trap to the air supply (
2, Fig. L
), which must NEVER exceed the “MAX DRAIN” level indicator on
the water trap itself.
When necessary, drain the water by turning the locking ring (
3, Fig. L
) clockwise.
- Every 30-40 days disconnect the machine from the compressed air circuit and dismantle the glass (
2, Fig. L
) to remove any solids
collected inside it.
WARNING!
If this machine catches fire, only use powder extinguishers or, alternatively, CO
2
extinguishers to put out the
flames.
Содержание S 45 TL
Страница 2: ...2 ITALIANO Manuale d uso S 45 TL I...