ENGLISH • Instructions manual
27
S 45 TL
S 45 TL
2
C6
1
C5
Fig. C4
) labelled in the same way.
Then connect the hose (
8, Fig. C4
) to the hose (
10, Fig. C4
).
6)
Close the left-hand side panel.
6.4 FIXING TO THE GROUND
1)
Prepare the following tools:
N. 1 - Hex spanner 13
N. 1 - Electric drill
N. 1 - Concrete drill bit diam. 13 long
N. 4 - Metal expansion screw anchors 13x50
N. 4 - M 8 x 50 anchor screws.
2)
Drill four holes in the floor corresponding to the holes pre-drilled in the base. Holes should be 80 mm deep. Use the long, 13 mm concrete
drill bit.
3)
Insert the expansion plugs and tighten with the 13 mm spanner.
6.5 PNEUMATIC HOOK UP
For correct pneumatic hook-up, proceed as follows:
1)
Lower the pedal (
5, Fig. D
) all the way down to avoid sudden opening of the
clamps.
2)
Connect the machine to a compressed air supply (with recommended operating
pressure of 8 - 10 bar) by means of the coupling (
1, Fig. C5
) supplied as standard,
using a 7 – 8 mm (internal Ø) rubber hose for compressed air.
WARNING!
The compressed air pressure must not exceed 16 bar.
3)
A connection (
2, Fig. C6
) can be fitted on the back to fit an inflation gun.
WARNING!
Use the union (2, Fig. C6) only for the outlet of air (to
connect inflating device).
Do not connect the compressed air network to this union:
you could break the pneumatic equipment and the safety
devices.
6.6 ELECTRIC HOOK UP
Before making any electric hook up, check to be certain that the mains voltage corresponds to what is stamped on the voltage tag
(attached on the feeding cable of the tyre changer).
It is absolutely essential that the system is equipped with a good grounding circuit.
The machine must be connected to a power supply line circuit breaker set for 30mA.
Note the required power draw as highlighted on the tag-plate fixed to the back of the tyre changer.
Содержание S 45 TL
Страница 2: ...2 ITALIANO Manuale d uso S 45 TL I...