Siborg LCR-Reader-MP, Руководство пользователя

Страница: 8 / 27

LCR-Reader-MP Manual Siborg Systems Inc. 7
6 Device Controls
6.1 Turning On the Device
Press the jog-wheel down and wait until the device beeps.
6.2 Turning Off the Device
1. Press the jog-wheel and hold it until the device shows “Shutdown” .
2. Hold with screen down for 3 beeps (may be enabled via menu).
3. The device turns off if it has been inactive for 120 seconds (default). The automatic time-off setting
can be changed in the menu:
System /Power/Time Off
6.3 Extended Voltage Range Switch
The switch is located at the left bottom of the housing. This switch
extends the range of the voltage measurements. In the Voltage and
Frequency modes, the side switch in Position 2 increases the input
impedance of the device from 1 kΩ to 10 MΩ and extends the range
of input voltages.
For RLCD and RD measurements, the switch should be set to
Position 1.
6.4 Controlling Device Using Its Orientation
1. If you rotate and hold the device perpendicular to the floor the screen will flip orientation to the
hand being used. *
2. Turn the probes up to turn on/off the indicator light
3. If you place the device on a flat surface with the
screen facing up, after a few seconds the device will
go into Economy mode. The display shows the
battery voltage and the firmware number. *
4. If you place the device on a flat surface with the
screen down, after 3 beeps the device will
automatically turn off. *
*Function can be enabled/disabled through the device menu: System/Power
6.5 Charging the Battery
The device is powered by a Li-Po battery with 3.7 V rated voltage. The battery icon on the display shows
the remaining charge of
the battery. This icon will blink when the device’s power is below 3.6 V and will
automatically turn off at 3.5 V. Information about the battery voltage can be displayed in the menu:
System/Power/Battery Voltage
Charge the battery by connecting it via a
micro-USB cable to a USB DC voltage
source of 5V +/-
5%. The device’s indicator
light will show when the device is charging and will
turn off when the charging is complete.