Shindaiwa EGW165M-I/UKV, Руководство владельца и оператора

Страница: 18 / 40

- 12 -
(2) Unlock the wheel
Slide the brake arm to position 1 and then down
to default position 2.
<Caution>
 Be sure to unlock the brake, before attempting
to move the equipment to avoid a locking
system malfunction.
5-10. Earth Leakage Circuit Breaker and Grounding
(1) Grounding Work
A qualified electrician should perform the
grounding work of the following 2 points (500 Ω
or below).
The grounding terminal of this equipment.
The Outer Bonnet of the load.
<Caution>
 In the event you cannot ground the generator
to the earth, consult with the authorized
distributor or our dealer.
(2) Operation Check
Before operating the equipment, please follow
the instruction below.
1. Start the engine as per starting procedure.
Please refer to 6-2 Starting (P. 17).
2. Turn the AC output switch to [ON] position.
3. Switch the ELCB to [ON] position.
4. Press the test button (Gray) in the ELCB.
(Once the test button is pressed, the ELCB indicator (White) must be out and the
switch in the middle position.)
5. Push down the ELCB switch [OFF] position.
6. Return the ELCB switch to [ON] position.
(The ELCB indicator (White) will return to its original position)

In the event you cannot complete all 6 steps in the above procedure, the ELCB is
faulty. Consult with our authorized distributor or our dealer to repair.
Warning: Electric Shock
 Ground the grounding terminal to the earth as set out in the manual.
Failure to do so could result in injury.

Even though all the load terminals have been grounded to the earth, the canopy
grounding terminal should also be grounded to the earth.
 Grounding should be made whilst the engine is stopped.
 Whenever the earth leakage circuit breaker has been activated, you should always
repair the fault before re-using the machine.
Wheel Unlock
ELCB
ELCB Indicator
Test Button
Earth Grounding Terminal
Grounding Rod