Shindaiwa EGW165M-I/UKV, Руководство владельца и оператора

Страница: 24 / 40

- 18 -
<Caution>
 Never turn the starter switch to [START] position once the engine is running.
6. Push back the choke.
<Caution>

Just after starting, the engine may stop if the choke is prematurely pushed back in. In
this case, push back the choke slowly once the engine is warm.
7. Keep engine idling for approximately 5 minutes.
(2) Starting by Recoil Starter
1. Switch the AC output switch to [OFF] position.
2. Turn the fuel valve to [OPEN] position.
3. Pull out the choke.
4. Turn the starter switch to [RUN] position.
5. Open the side door.
6. Pull the recoil knob slowly to the compression
point, then allow the recoil knob to return and
pull it again to start.
<Caution>
 Do not fully extend the recoil knob.
7. After the engine starts, push back the choke.
<Caution>
 Just after starting, the engine may stop if the
choke is prematurely pushed back in.
Therefore, push back the choke slowly along
the engine condition and keep the choke back
always when the engine is warm.
8. Keep engine idling for approximately 5 minutes.
[OPEN]
Fuel Valve [CLOSE]
Recoil Knob Side Door
Starter Switch
ELCB
Choke
AC Output Switch