Shindaiwa EGW165M-I/UKV, Руководство владельца и оператора

Страница: 33 / 40

- 27 -
(5) Clean Exhaust Wire Mesh
Clean Every 500 hours
1. Loosen the bolt and remove the exhaust wire mesh and holder.
2. Clean off the carbon deposits from the exhaust’s wire mesh using a wire brush.
3. Reassemble it in reverse order.
(6) Checking the Battery
1. Open the front door.
2. Make sure that the battery cables are firmly
secured to the posts. Tighten the clamps if
necessary.
<Caution>
 Check and measure the voltage between
terminals. If it is lower than 12.8 V, recharge is
necessary.
Holder Exhaust Wire Mesh
Fuel Valve
Net
Seal
Strainer Cup
Ring
Warning: Explosion

The battery may emit some combustible gas. Keep it away from fire and sparks.
 A loose battery terminal can be a cause of sparks.
Caution: Injuries to eyes and skin
 The battery used in the equipment is the sealed type 12 V. Therefore, it is not
necessary to check the liquid level or replenish water. Do not remove the sealed
plug.
 Battery fluid contains diluted sulphuric acid. Avoid contact with eyes, skin and
clothing. If the acid comes into contact with eyes, flush with lots of water, and seek
medical attention immediately.
Bolt
Muffler
Strainer
(+) Terminal
Battery
(-) Terminal