Shindaiwa DGW400DMK, Руководство владельца и оператора

Страница: 40 / 48

- 37 -

Error Code Display
Error codes are displayed on the DC and AC
meters when the control board detects an error.
If the error code is displayed, follow to the
procedures in the "Remedy".
Error
Code
Symptom Remedy
E01
Overheating
of control parts
for welding
Set the idle control switch to "AUTO" or "ECO".
Run the engine to cool it down at idle under no-load until the "E01"
display disappears.
* This error is automatically resolved when temperature of the
control parts lowered to normal.
E02
Fault/Malfunction
of control parts
for welding
Stop the engine and repair the location of the fault.
* DO NOT restart the engine unless the fault is repaired.
E03
Short circuit
of the weld output
Stop the engine.
Return the short circuit of the weld output and restart the engine.
E07
Overheating
of alternator
As the engine continue to run even after "E07" is displayed, remain
the engine run for approx. 10 minutes to cool the alternator down.
Display will change "E07" to "
・・・
" after engine run for approx. 10
minutes. Then, stop and restart the engine.
* When the alternator will not cool down insufficiently, "E07" is
displayed again and repeat the remedy.
* Engine rpm remains the same when this failure happens although
position of the idle control switch is changed. The rpm is unchanged
after the sensor detects overheat until it is fixed.
  
Starter Switch
is kept at ON
Turn the starter switch to "STOP" position.
Restart the engine once the switch is turned to "STOP".
* "
・・・
" is also displayed when "E07" is displayed and engine run for
approx. 10 minutes.
<Note>

Maintenance of this equipment must be performed by specialized technicians.

When performing maintenance with doors or covers open, be sure that no other
persons can accidentally come close to the equipment. Close all doors and covers if
momentarily leaving the equipment unattended.

A simple inspection cannot always resolve some problems. If you cannot resolve a
problem after inspecting the equipment, request repair at the retail outlet where the
equipment was purchased.
Error Code Display