Shindaiwa DGW400DMK, Руководство владельца и оператора

Страница: 33 / 48

- 30 -
(1) Changing the Engine Oil
1) Remove the oil plug.
2) Remove the oil drain plug and drain the
engine oil.
3) Tighten the oil drain plug.
4) Add oil through the oil inlet, while checking
the oil level using the oil gauge, until it
reaches the maximum level. (Fill with approx.
3.6 L)
5) Tighten the oil plug.
<Note>

Refer to section "7-1. Engine Oil Inspection" for the types of engine oil.

Replace the packing of the oil drain plug with a new part each time the oil is changed.

Packing part no. : 6C090-58961 (Kubota part no.)

After tightening the oil drain plug, operate the engine for a short period and check that
there is no oil leakage. Stop the engine when completed.
(2) Changing the Oil Filter
1) Drain the engine oil according to the
procedures of "(1) Changing the Engine Oil".
2) Remove the oil filter using a filter wrench.
3) Apply a thin layer of oil to the gasket of a new
oil filter.
4) Screw in the oil filter by hand and securely
tighten by hand (do not use a filter wrench)
after the gasket contacts the seal surface.
5) Add engine oil.
<Note>

Contact the retail outlet where the equipment was purchased if you do not have a filter
wrench.

Oil filter part no. : 15853-32437 (Kubota part no.)

After adding engine oil, operate the engine for a short period and check that there is
no oil leakage. Stop the engine when completed.
1st time 50th hour
2nd time
and after
Every 100 hours
1st time 50th hour
2nd time
and after
Every 200 hours
Gasket
Oil Plug
Oil Inlet
Oil Gauge
Oil Drain Plug
Oil Filter
Oil Plug
Oil Inlet