Shindaiwa DGW400DMK, Руководство владельца и оператора

Страница: 12 / 48

- 9 -
5. Equipment
5-1. Spill Containment
Warning: Fire

Always be sure to wipe up any spilled fuel or oil.

Spilled fuel and oil accumulates in the spill containment. Do not operate the
equipment with liquid accumulated in the spill containment.

Absolutely never use the equipment if there is a fuel, oil or cooling water leak, and
be sure to always repair the leak before using.
The equipment includes a spill containment (structure that collects leaking liquid) in
order to prevent leaking liquid from getting outside of the equipment if oil, fuel or other
liquid should leak. Before starting operation, check if there is any fluid accumulated in
the spill containment and drain any accumulated liquid. (Refer to section "12.(7)
Draining Liquid from the Spill Containment".)
<Note>

It is necessary to periodically drain the liquid from within the equipment because any
rainwater that leaks into the equipment also accumulates in the spill containment.

Although the fluids that can leak internally consist of oil, fuel and cooling water, the
spill containment does not have a function that can separate rainwater that has leaked
into the equipment from these internally leaked fluids. Properly dispose of liquid
drained from the spill containment in a manner according to the applicable laws and
regulations.
5-2. Idle Control
The equipment includes an idle control function.
You can use the idle control switch to select an
engine speed setting of "ECO", "AUTO" or "HIGH".
(1) ECO Drive
The equipment includes an eco drive function in
order to reduce noise, save fuel, and reduce
exhaust gas emission.
When the idle control switch is set to "ECO" and only welding is being performed, the
engine operates at an optimal speed corresponding to the weld output and it
automatically returns to low speed when welding is stopped.
The eco drive display lights up during eco drive to indicate that operation is
environmentally considerate.
<Note>

The engine speed optimization function of eco drive is only for
"DROOP" and "CC" welding. (It does not function if "CV-WIRE"
is selected using the weld mode selector.)

If using as an AC power source during eco drive (including
when welding and using as an AC power source at the same
time), the engine operates at high speed and the eco drive
display turns off.

Set the idle control switch to "AUTO" or "HIGH" if welding or using as an AC power
source in an intermittent manner.

Set the idle control switch to "HIGH" if using a high capacity motor, precision
instruments or AC load with an attached magnetic switch.

Set the idle control switch to "HIGH" if using as an AC power source of a device of
0.5A or less because the engine might not reach a high speed as speed control does
not operate at that level.
Idle Control
Switch
ECO Drive Display