shelolab SMO5HP-2, Руководство по эксплуатации и установке

Страница: 26 / 42

26 | P a g e
OPERATION
P
UT THE
O
VEN INTO
O
PERATION
Carry out the following steps and procedures to put the oven into operation after installing it in a new
workspace environment.
End of Put the Oven into Operation
1
Place the oven Power Switch in the on ( I ) position.
The controller display will illuminate, show the current firmware
revision number, and then default to the homepage.
2
Carry out the following procedures found in the Operation section:
•
Set the Temperature High Limit for your application, page 27.
•
Optional: After setting the High Limit, you may set the constant
temperature set point to a warm-up temperature or to your
constant temperature baking set point. Read Set the Constant
Temperature Set Point , page 28.
•
Read the Programing Profile Guide that came with the unit if will
you will be programming multi-step automated heating recipes
to run the oven with.
3
Optional : If you are required to validate or verify the accuracy of the
temperature display for regulatory or industry standards compliance,
perform the Set Up andthe first step of the Calibrate the Temperature
Display procedure in the User Maintenance chapter. See page 34.