EN-7
Insert securely to as far as it goes.
Power plug
Charger
-
1
2
3
CAUTION
Notices
EN-6
EN-16
Battery release button
CAUTION
1
Turn
2
3
Turn
Click!
Protrusion
EN-17
EN-17
EN-17
Top side
Warning
PREPARATION
See for
tips for making the
battery last.
Charging battery
The battery is not charged when the product is purchased, so the battery must be removed from
the vacuum cleaner body and charged until the Charging lamp on the charger is turned off.
Remove the battery from the vacuum cleaner body.
Insert the power plug of
the charger in the power
outlet.
Set the battery on the charger and recharge.
Align the terminals.
Verify that the Charging
lamp (red) is turned on.
If the lamp blinks (repeating the "blinking" in
intervals of about one second) the battery has
not been securely inserted.
Insert the battery securely to as far as it goes.
Remove the battery by
sliding it in the direction
of the arrow.
Press the Battery release
button in the direction of
the arrow
The estimated duration of
time required for charging
varies depending on the
remaining charge in the
battery at the time charging
starts.
Do not touch the terminals of the charger or the
battery since they become hot while charging
or immediately after completing charging. [Risk
of burns.]
Do not apply any hot air, such as air blown by a hair dryer.
[Risk of deformation or product malfunction.]
Caution is required to ensure that the
Mesh filters (Upper and Lower) are
not lost while throwing out dirt or
cleaning.
Each part must be assembled
correctly in order for them to fit onto
the vacuum cleaner body.
Align the protrusion on the Dust Cup and the
Dust disposal hook (yellow) and insert.
Align the salient part of the Pleat
filter to the recessed section of the
Filter Cover and press in.
Install the Filter Cover and the Mesh
filters (Upper and Lower).
Install the Dust Cup.
Align the
positions..
Align the
positions..
Install the Dust Cup.
Properly remove moisture, gently wipe off moisture
with a towel or the like, dry in shade at a well
ventilated location to thoroughly dry.[Risk of
emission of odor or product malfunction.]
Thoroughly dry prior to assembling.
[Risk of filter clogging not improving even after
cleaning.]
Wash with water or thinned neutral detergent.
Pleat filter (blue)
Remove dirt and dust with a cleaning brush.
Dislodge and remove dirt and dust by
dusting.
Pleat Filter
Parts that may be washed with water
Dust in the direction illustrated in
the diagram on the right as dirt
tends to accumulate on the back
side.
Do not use a cleaning brush
[Risk of damages].
Mesh filters (Upper and Lower), Filter Cover
When heavily dirtied, wash with water.
Cleaning the Filters
Assembling the Filters
Filter Cover
Carefully wash
the back side.
When the odor stands out,
dilute bleach for clothing in
water and immerse the filter
in this solution following
instruction for the bleach,
then rinse with
water.
Mesh filter
Dust Cup
Dry the parts after washing with
water.
Estimated
drying time:
12 hours.
(This may vary depending on
the environment and season.)
The charger or the
battery becomes hot
while charging, but this
is not abnormal.
Lamp state
Charging status
Charging
Turned on
Turned off
Charging completed
(fully charged)
About 80 minutes
Estimated duration from start
of charging*
[Risk of electrocution or injury.]
Always do followings during maintenance
Disconnect the power cord of the charger from the
electrical outlet.
Press the to stop the operation of the product
and remove the battery.
Dust
disposal
hook
(yellow)
Recessed
section
Salient
section
Gently rub
the mesh.
ENGLISH
(Shape of plug depends on country)
各部份名稱
各部份名稱與組裝方法
以直立狀態使用時
右側面
要拆下各零件時，請以同時按住「裝卸按鍵」的方式拆下。
電池
排氣口
內建式濾網無法拆下。
不須保養。
電池拆卸鍵
CN-7
CN-7
CN-15
、
16
CN-4
、
7
集塵筒組
垃圾清理鍵（黃色）
濾網盒部位
摺疊濾網
集塵筒
垃圾會累積在此處。
濾網盒
圓筒形濾網
濾網保養燈（紅色）快速閃爍時，請用水清洗各濾網。
按下垃圾清理鍵（黃色）後，將分離成集塵筒與濾網盒部位
兩個部位。
附屬配件
上述的
「地板吸頭」
與
「延長管」
亦屬於附屬配件。
充電器（
1
個）
鋰電池（
1
個）
清潔刷（
1
個）
電線
（約
80cm
）
（包裝時安裝於充電器）
（裝在主機上）
使用後請依照圖中
方向裝入。
端子
以乾布擦拭污垢。
充電部位的接點（端子）
齒輪
套上皮帶
左右方向相反時，
無法裝上。
將皮帶套住旋轉刷的齒輪，並放入溝槽中。
將旋轉刷無齒輪的一方插入溝槽最深處。
將開關拉桿朝箭頭指示方向滑動。
將刷頭保護蓋的扣爪扣住溝槽進行安裝。
齒輪
溝槽
溝槽
扣爪
刷頭保護蓋
注意！
請避免吹到吹風機等機器的熱風。
【否則將造成變形或故障】
請勿使用清潔劑、稀釋劑、揮發油、
以及熱水（約
40°C
以上）。
【否則將造成變質或變形】
安裝
警 告
【否則將造成觸電或受傷事故】
保養時請務必遵守以下事項。
充電器需將電源插頭拔出。
主機需按下 停止運作後，再拆下電池。
指示燈
主機把手／開關
搬運時請務必握住主機把手。握住其他
部位（延長管或集塵筒等）時，會使主
機脫落或傾倒，造成受傷事故或故障。
反面
固定墊
集塵筒拆卸開關
（黑色）
CN-10
、
19
裝卸按鍵
裝卸按鍵
延長管
地板吸頭
CN-17
CN-13
CN-6
CN-9
CN-11
、
12
附屬吸頭
除塵毛刷吸頭（
1
個）
狹縫吸頭（
1
個）
CN-5
CN-18
中文
(插頭圖樣並不代表該國家所使用的插頭)
EC-A1RHK_A4(W page imposition).indd 15-16
2018/12/06 14:26:59
