●
●
●
操作方法
開關
操作流程
開始
結束
每次按下時，將在「強力模式」
⇔
「標準模式」之間進行切換。
強力模式：希望以最大吸力清掃時
標準模式：希望降低吸力清掃時
（吸住踏墊或小型地毯等物品時）
清掃完成
CN-7
CN-17
CN-13
、
14
CN-15
、
16
CN-15
、
16
電池充電
基於衛生考量，建議每次清掃
時皆清空垃圾。
重要須知
安全停止
開始清掃後，吸頭上的旋轉刷將自動開始旋轉。
清潔踏墊和小型地毯等時可能會有異物進入吸頭導致旋轉刷停止。
這種情況下，請使用標準模式清潔。
即使於標準模式下結束清掃，下次按下 時，仍會以強力模式開始運作。
電池剩餘電力於運作期間耗盡時，將自動停止，以避免因過度放電造成電池劣化。
不論使用時間長短，清掃完畢後請務必對電池充電。
清掃期間將吸頭（反面的安全滾輪開關 ）抬離
地板時，旋轉刷將自動暫停以確保安全。此時運作動作
不會停止。
將吸頭貼在地板上移動後，即會繼續旋轉。
注意！
暫停期間請勿觸碰旋轉刷或安全滾輪開關。
【否則將造成旋轉刷開始運作，引發受傷事故。】
保養吸頭時，請務必先按下 停止運作後，再開始保養。
即使吸頭仍貼著地板，
但安全滾輪開關離開地
板時依然會暫停。
清理垃圾
安裝
拆下集塵筒清空垃圾。
按下濾網盒部位
側面的清理垃圾
鍵（黃色）。
握住濾網盒部位
向上抬高
濾網盒部位
垃圾清理鍵
（黃色）
請確認集塵筒的底部是
否無垃圾殘留。
以清潔刷清除圓筒形濾網上的垃圾。
圓筒形濾網
無垃圾纏繞時
保養集塵筒組。
長期持續使用後
內建的摺疊濾網將積滿灰塵。
請進行保養。
安裝集塵筒。
將集塵筒的突起處對準垃圾清理鍵（黃色）後，
將其推入。
咔嚓
突起處
垃圾清理鍵
（黃色）
注意！
清理垃圾或保養時，請
注意避免遺失圓筒形濾
網（上／下）。
集塵筒組必須事先組裝完成，
否則無法確實安裝至主機上。
未將摺疊濾網安裝於集塵筒
上時，無法安裝至主機上。
未將集塵筒組確實安裝於主
機時，將引發吸力減弱、發
出異常聲響、垃圾混入馬達
中等故障。
咔嚓
朝箭頭指示方向確實推入
鉤扣
(藍色)
卡槽部位
將集塵筒的卡槽部位扣住主機
上的鉤扣
(藍色)
。
將集塵筒組安裝至主機上。
CN-9
CN-14
中文
●
EN-7
Insert securely to as far as it goes.
Power plug
Charger
-
1
2
3
CAUTION
Notices
EN-6
EN-16
Battery release button
CAUTION
1
Turn
2
3
Turn
Click!
Protrusion
EN-17
EN-17
EN-17
Top side
Warning
PREPARATION
See for
tips for making the
battery last.
Charging battery
The battery is not charged when the product is purchased, so the battery must be removed from
the vacuum cleaner body and charged until the Charging lamp on the charger is turned off.
Remove the battery from the vacuum cleaner body.
Insert the power plug of
the charger in the power
outlet.
Set the battery on the charger and recharge.
Align the terminals.
Verify that the Charging
lamp (red) is turned on.
If the lamp blinks (repeating the "blinking" in
intervals of about one second) the battery has
not been securely inserted.
Insert the battery securely to as far as it goes.
Remove the battery by
sliding it in the direction
of the arrow.
Press the Battery release
button in the direction of
the arrow
The estimated duration of
time required for charging
varies depending on the
remaining charge in the
battery at the time charging
starts.
Do not touch the terminals of the charger or the
battery since they become hot while charging
or immediately after completing charging. [Risk
of burns.]
Do not apply any hot air, such as air blown by a hair dryer.
[Risk of deformation or product malfunction.]
Caution is required to ensure that the
Mesh filters (Upper and Lower) are
not lost while throwing out dirt or
cleaning.
Each part must be assembled
correctly in order for them to fit onto
the vacuum cleaner body.
Align the protrusion on the Dust Cup and the
Dust disposal hook (yellow) and insert.
Align the salient part of the Pleat
filter to the recessed section of the
Filter Cover and press in.
Install the Filter Cover and the Mesh
filters (Upper and Lower).
Install the Dust Cup.
Align the
positions..
Align the
positions..
Install the Dust Cup.
Properly remove moisture, gently wipe off moisture
with a towel or the like, dry in shade at a well
ventilated location to thoroughly dry.[Risk of
emission of odor or product malfunction.]
Thoroughly dry prior to assembling.
[Risk of filter clogging not improving even after
cleaning.]
Wash with water or thinned neutral detergent.
Pleat filter (blue)
Remove dirt and dust with a cleaning brush.
Dislodge and remove dirt and dust by
dusting.
Pleat Filter
Parts that may be washed with water
Dust in the direction illustrated in
the diagram on the right as dirt
tends to accumulate on the back
side.
Do not use a cleaning brush
[Risk of damages].
Mesh filters (Upper and Lower), Filter Cover
When heavily dirtied, wash with water.
Cleaning the Filters
Assembling the Filters
Filter Cover
Carefully wash
the back side.
When the odor stands out,
dilute bleach for clothing in
water and immerse the filter
in this solution following
instruction for the bleach,
then rinse with
water.
Mesh filter
Dust Cup
Dry the parts after washing with
water.
Estimated
drying time:
12 hours.
(This may vary depending on
the environment and season.)
The charger or the
battery becomes hot
while charging, but this
is not abnormal.
Lamp state
Charging status
Charging
Turned on
Turned off
Charging completed
(fully charged)
About 80 minutes
Estimated duration from start
of charging*
[Risk of electrocution or injury.]
Always do followings during maintenance
Disconnect the power cord of the charger from the
electrical outlet.
Press the to stop the operation of the product
and remove the battery.
Dust
disposal
hook
(yellow)
Recessed
section
Salient
section
Gently rub
the mesh.
ENGLISH
(Shape of plug depends on country)
EC-A1RHK_A4(W page imposition).indd 33-34
2018/12/06 14:27:02
