收納
重要須知
更換電池
收納方式
請於牆壁與家具間的縫隙、房間牆角、衣櫃內等不易傾倒的地點，
以將固定墊扣住家具等物品的方式，進行收納。
注意！
直接靠在牆上時，可能會翻覆，請多加注意。
部分種類的牆壁與家具，可能會因為固定墊摩擦而變
髒，請多加注意。
地板或家具等物品過於平滑，無法扣住時，請勿強行
扣住，請以分解的方式收納。
請確認周圍有無容易損壞的物品。
尤其應注意避免嬰幼兒與寵物靠近。
固定墊
反面
長期間不使用時，請先調整成下
圖中的狀態後，再行收納。
亦須注意的其他事項
長時間不使用注意事項
地板吸頭反面的安全滾輪開關、車輪、緩衝毛墊已磨損時，
可能會刮傷地面。
車輪
緩衝毛墊
與吸頭一體
與刷頭蓋一體
緩衝毛墊
安全滾輪開關
部位已磨損時，必須更換
為新品。
請停止使用，並洽詢客戶服
務中心。
的零件需以送修方式
修理。
更換用零件（皮帶保護蓋）
可單獨選購。
吸塵機避免吸入以下物品。
（否則可能造成內部受損、垃圾堵塞、或故障）
吸塵機吸入細小的粉末類（石膏、水泥、粉筆等）物質時，
請保養各濾網。
不可用於打掃赤腳行走的玄關處。
不可讓吸塵機吸入大型垃圾，或一次吸入大量垃圾。
尖銳的物品（玻璃、刮鬍刀等）。
液體或潮濕的垃圾。
請勿對旋轉刷加油（否則可能造成塑膠龜裂）。
請勿拖行充電器（否則可能刮傷地板等處）。
請勿將吸頭用力頂住地板與門檻的高低差部分、家具、
以及牆壁等處（否則可能刮傷地面等處）。
不可在拆下集塵筒組 的狀態下運作。
CN-5
CN-15
、
16
大量砂礫
繩索類
本充電式吸塵機為家庭用，請不要當作商用
吸塵機使用。
此外，請不要使用在吸地以外的用途上。
運作期間可能會造成電視機畫面出現雜訊，
但不會對電視機造成影響。
建議拔掉充電器電源插頭。
維持在插入電源插頭狀態時，
將耗用約
0.5W
的電力。
不需使用時請拔掉電源插頭，可避
免耗電。
CN-7
請由主機上拆卸電池，並務必將
電池完全充滿電之後，再進行保
存。
請勿與鐵絲、項鍊、耳環等
金屬類一同搬運及收納。
請保存於濕氣和灰塵較小的地方。
（否則可能造成發熱、起火燃燒、觸電）
經長時間存放後，可能需對電池充電、
放電數次以達到其最大效能。
收納電池時，請注意以下事項。
電池的更換基準
CN-6
在低溫（約
5°C
以下）或高溫（約
35°C
以上）
的環境中充電，充電器的充電指示燈（紅色）
緩慢閃爍時，屬於正常現象，絕非故障。
請於
5°C
∼
35°C
的環境中充電。
端子
請以市售的絕緣膠帶等物品將端子部位絕緣，並請勿將其分解。
請根據當地政府制定的規則進行處理。
不再使用之電池的處理方式
請協助回收電池。
電池（鋰離子電池）為可回收使用的珍貴資源。
不需再使用的電池請勿丟棄，並送至提供充電式電池回收服務的店家。
電池屬於消耗品，會因反覆使用而導致運作時間逐漸縮短。
雖然電池的劣化速度會因使用狀況與工作環境而改變，但只
要出現以下任一情況時，即請更換電池。
每次在室溫
5°C
∼
35°C
的環境中充電時，充電器
的充電指示燈（紅色）皆緩慢閃爍時。
即使已完全充滿電，仍只能運作極短時間。
CN-19
CN-4
中文
EN-6
EN-17
Rotary brush cover
EN-16
EN-4
Removal
CAUTION
Wheel
Rotary brush cover
Release lever
Belt
Gear
MAINTENANCE
Suction head, vacuum cleaner body,
Enclosed nozzles and contacts
(terminals) of charging section
Suction head (Rotary brush)
Vacuum cleaner body, Enclosed nozzles and
contacts (terminals) of charging section
When lint, rubber band, hair or pet hair and the like is attached.
Removing the dirt
Roller
Switch
Napped cushion
Remove dirt that became attached to
fine parts with a pair of scissor or a pair
of tweezers with thin tips.
Cut along the slot of the Rotary brush for
removal.
(Do not cut the tips of the bristles of the brush.)
Remove the dust attached to the
Suction head with a Duster Nozzle
and cut off the hair and lint
entangled in the section and then
wipe with wrung cloth.
Stop using the product when the section
becomes worn, check and contact
your nearest service center approved by
SHARP.
When heavily dirtied
Vacuum cleaner body
Wipe with cloth moistened with some water
or thinned neutral detergent. Do not use any
paint thinner or benzene product. [Risk of
deterioration or discoloration]
Enclosed nozzles
Release
button
When using the product in the
Handy state
Wash with water
or thinned neutral
detergent.
The vacuum cleaner body,
charger and battery cannot
be washed with water.
Dry the parts after washing
with water.
Press Release button to remove
respective parts.
Remove the Rotary brush cover by sliding the
Release lever to the "OPEN" position.
The Suction head cannot be washed with water in its entirety.
When heavily dirtied
Wash with water
Remove the belt from the gear while lifting up the
Rotary brush and remove the Rotary brush.
After removing the Rotary brush and washing it with water,
remove water and moisture properly and sufficiently dry in
a ventilated location before re-installing.
Rotary brush
Remove
the belt
Click!
EN-4
Tips for making the battery last
Charge the battery every time the product is used,
regardless of how long it was used.
When the product is not used for a long time
Recommended Time for replacing the battery
About 1,100 times of charge/discharge
◆
The battery lasts longer when charged before the charge level
becomes low.
Leaving a discharged battery without charging will lead to the
deterioration of the battery.
According to tests conducted based on Sharp's standard
for repeatedly charging and charge/discharge a battery.
The life of a battery can vary depending on the conditions
of use and the environment.
*2
*1
EN-7
Lamps notify status of the vacuum cleaner body
Filter care lamp
(red)
Battery level indicator
lamp (green) *1
Indicated State/ Explanation
Lamp State
Filter care lamp (red)
Battery level indicator
lamp (green)
Turned
on *2
Fast
blinking
Turned on
Blinking
Fast
blinking
The filter of the Dust cup assembly is dirty.
Clean the filter by rinsing with water.
There is sufficient charge remaining in the battery.
The charge remaining in the battery is low.
The filter of the Dust cup assembly is clogged with dust.
The vacuum cleaner body is overheating.
Leave the product in a cool place for a while.
Operating the product without allowing it to cool leads to the
overheating protection circuit of the vacuum cleaner body triggering,
which disables the product for some time.
The charge remaining in the battery is quite low.
(There is no charge remaining in the battery.)
Charge the battery.
Empty the dust cup and clean the filter.
The Battery level indicator lamp is turned on in following situations. (The lamp is not turned on when there
is no charge left in the battery.)
The lamp may also turn on when the Suction head is clogged even when the filter is not dirty.
In such instances, press the and then restart operation to turn the lamp off.
(The lamp goes off in about 10 seconds after the machine is stopped.)
About 5 seconds after the battery is reinstalled on the vacuum cleaner body.
While using the product for cleaning
About 5 seconds after pressing the and stopping the operation of the product.
EN-13, 14
EN-15, 16
ENGLISH
EC-A1RHK_A4(W page imposition).indd 13-14
2018/12/06 14:26:58
