User’s guide
HRP/D
-
32
-
HS
Maintenance
10
10.4.2
Emptying
1.
Disconnect the compressed air.
The top frame will lower slowly.
2.
Remove the left-hand frame plate on the front of the
machine.
3.
Remove the 2 screws in the front of the Timer unit, and 1 in
the back of the timer unit.
4.
Lift the back of the Timer unit a bit, so that you can put a
container underneath the Glass Holder (if necessary,
remove some connectors to make room as explained in
section
12.3
. These are not interchangeable, and so they
cannot be put in the wrong socket. Before performing this
action,
make sure the main power switch is off!
)
5.
Slowly open the nipple. All the water will then run out of the
glass holder, in the container underneath.
6.
Close the drain nipple by hand.
7.
Reposition the Timer unit, and all the connectors that may
have been removed earlier. Screw the Timer unit back into
place.
8.
Screw the left-hand frame plate on the front of the
machine back in position.
9.
Switch the machine on again as described in Section
7
.
Содержание HRP/D
