User’s guide
HRP/D
-
27
-
HS
Alterations
9
2.
Place the heating element in position and fix it with a
socket head screw (M6x12 countersunk) in the centre.
(Use socket screw key
no. 3
). Do not tighten fully at this
point.
Make sure that the long pin on the heating element is on the left side
of the machine.
3.
Position the heating element. (See section
8
).
4.
Hand tighten the socket head screws,
starting
at the side
and
then
in the centre.
5.
Connect the wires to the terminals on either side of the
machine. Insert the forked tongue under the rotary knob
and tighten the knob firmly by hand.
Always use terminals of the same colour on both sides
of the machine.
Never use pliers. This could damage the terminals.
6.
Fill the space between the heating elements as far as
possible with solid core strips and hand tighten them. First
slide the notched nuts into the aluminium
X
-profile
approximately level with the holes and then place the solid
core strip on top.
7.
Switch on the machine as described in Section
7
.
5
2
Содержание HRP/D
