User’s guide
HRP/D
-
17
-
HS
Operation
7
7.7
SETTING CYCLE TIME
The time during which the machine is closed to heat
the plastic sheet on two sides is set using the
electronical timer
K
.
7.8
HAND OR FOOT OPERATION
Select hand or foot operation using switch
F
.
Position 1:
Hand operation.
The frame closes when switch
H
is
pressed.
Position 2:
Foot operation.
The frame closes when the foot pedal is pressed.
Press switch
G
(arrow up) to open the machine before the end
of the set time. The timer (
K
) is returned to
0
.
7.9
SET AIR PRESSURE
Control the pressure in the system with reducing valve
M
, which
can be found on the water separator (see
10.4
, page
30
). The air
pressure is set by the factory at
6 bar
.
N.B. To right:
valve open
To left:
valve closed
press knob in:
lock
pull knob out:
unlock
Always lock the reducing valve when the air is being
disconnected from the machine.
7.10
RESET RIBBON SWITCH
When the ribbon switch is touched the machine opens immediately. It is then
impossible to close the machine with the foot switch or pressure switch
H
. The red
lamp
E
will light. Press switch
D
to start the machine again. The green lamp in switch
D
will light.
M
Содержание HRP/D
