User’s guide
HRP/D
-
39
-
HS
Tensioning and changing the filament
13
13.3
CHANGING
1.
Turn the filament to the lowest position. (Only for bottom
heating).
2.
Unscrew socket head screw in the wire pin on the right.
(Use socket screw key
no.2
).
3.
On the left side slide the expanding pin with the spring out
of the pin block.
4.
Slide the spring off the expanding pin.
5.
Unscrew the expanding pin from the connection screw
(incl. connection wire).
6.
Remove filament from the expanding pin and the wire pin.
7.
Slide a new wire into the expanding pin and make sure
that the eye is pulled well into the pin.
8.
Screw the expanding pin on the connection screw (incl.
connection wire) and attach firmly.
Take care not to damage the expanding pin. Tightening firmly
by hand is sufficient.
5
7
Содержание HRP/D
