LE/LE-HC Series DVR User Manual
V1.4 October 2006
- 47 -
Disks
Use the Disks menu to configure network disks that the LE/LE-HC DVR uses to record data. If no
disk is connected, (No Device) appears in the Disk Device field.
Use the keyboard or mouse to enter the IP address and Volume of any connected network disk.
Click on the Test button to test if the drive is working correctly.
TV output
Use the TV Output menu to configure the video output for the LE/LE-HC DVR. The LE/LE-HC
DVR can support standard VGA computer monitors or TV (composite) compatible monitors. Set
the device type, standard, outputs and other parameters. Set the Camera (From) and Camera (To)
options to specify the range of cameras that are displayed in the cyclic display mode.
Use the keyboard or mouse to set each field. Ensure each field is set correctly before clicking OK.
If parameters are set incorrectly it could result in the display becoming unreadable and very
difficult to correct.
GPIO
The GPIO (General Purpose Input/Output) menu enables you to view the status of the input and
output devices such as switches, sensors, LEDs, and so on and view their status. These devices
can be attached to the unit to turn external alarms (outputs) on or off when the specified input
changes. When an alarm has been triggered, the GPI and GPO that are connected will show the
status of the input or output device. GPI devices will show NC (normally closed) or NO (normally
open) as the status of the switch. Depending on the input, you can change the status of the GPO
devices to On or Off as required.