LE/LE-HC Series DVR User Manual
V1.4 October 2006
- 21 -
Chapter 5: Using and Configuring the LE/LE-HC DVR with Remote
Control
All available settings of the LE/LE-HC Series DVR can be configured using the remote controller
included with the system or with mouse and keyboard in GUI mode or remotely from a connected
PC.
The remote control only works in Full Screen (remote control) display mode. The other display
mode is GUI (Graphical User Interface) mode, where a mouse is required. LE/LE-HC Series
DVRs are preconfigured to use the Remote Control Mode.
Configure the LE/LE-HC Series for a network with Remote Control
This section of the manual assumes that the unit has booted up in
Remote Control Mode.
Before the system can connect to a network or to the Internet, in cases
where it needs to be connected the following steps must be taken:
On the remote control, press the menu button. The top option is
“
System Setup
”. Select this and press
“OK”
on the remote Control
Use
the
Down Arrow
below the
OK
button to move down to
TCP/IP
Press
OK
Enter IP address, Subnet, Gateway IP and DNS from Section 5.3 g)
below.
Use
the
arrow keys
to select each item, and press
OK
. Then use
the numbers on the remote control to set the different addresses.
Once all the addresses have been entered, use the
down arrow
to
go to
Save and Reboot
and press
OK.
Using the Menus
The following is a list of the keys used on the remote control:
a) Using the Menus
Press the
Menu
button on the remote control to enter the “
System Setup
” menu. This will display
Figure 5.2. Once in that menu, use the
Up/Down arrow keys
to choose the option to configure
and then Press
OK
to select the configuration option required.
Figure 5.0
