LE/LE-HC Series DVR User Manual
V1.4 October 2006
- 11 -
Similar local configuration options are available with the GUI and IR interface, although the easiest
method for configuration is the remote configuration.
Advance Setting
After the initial login, typing in the URL in Section 3.4 will bring up the page in
Figure 4.4. Clicking on the
(System Setup) button will display the
screen which is partially shown in Figure 4.5 (Clicking on System Setup will
bring up a login prompt if the original Password and User ID do not have
sufficient privilege).
Making changes to the settings will often cause the LE/LE-HC Series DVR to
reboot when the done button is clicked. This is unavoidable, and video will
not be recorded while the DVR is rebooting. This process can take 3 to 4
minutes.
Each of the items in the list in Figure 4.4 are
covered in the following subsections of Section
4.3
a) System Information
This page gives information about the LE/LE-HC
Series DVR. Most of this information isn’t
required on a day to day basis, but may be
required by a network administrator or
Technician should the occasion arise.
b) Camera Settings
1. Video Source: Select camera to display
2. Brightness, Contrast, Saturation, Hue and
Quality: Change Brightness, Contrast,
Saturation, Hue and Quality here. These
parameters are applied to all cameras. To adjust
brightness of each individual camera, please use
“Gain Control” as described in Item 5.
3. Compression Boost: Selection can be “None”,
“Low”, “Medium” and “High” to adjust video
compression rate. The higher the “Compression
Boost” level, the smaller the compressed frames
become providing faster remote transmissions
and smaller recorded files but poorer video
quality.
Figure 4.4
Figure 4.5
