Page 2
Senstar LM100 Product Guide
Senstar Corporation
Website: www.senstar.com
Email address: [email protected]
E8DA0102-001 Rev D
February 14, 2020
Senstar and the Senstar logo are registered trademarks, and Senstar LM100 and Silver Network are trademarks of Senstar Corporation.
Product names and Company names included in this document are used for identification purposes and are the property of, and may be
trademarks of, their respective owners. Copyright © 2017, Senstar Corporation, all rights reserved. Printed in Canada.
The information provided in this guide has been prepared by Senstar Corporation to the best of its ability. Senstar Corporation is not responsible
for any damage or accidents that may occur due to errors or omissions in this guide. Senstar Corporation is not liable for any damages, or
incidental consequences, arising from the use of, or the inability to use, the software and equipment described in this guide. Senstar
Corporation is not responsible for any damage or accidents that may occur due to information about items of equipment or components
manufactured by other companies. Features and specifications are subject to change without notice. Any changes or modifications to the
software or equipment that are not expressly approved by Senstar Corporation void the manufacturer’s warranty, and could void the user’s
authority to operate the equipment. The figures included in this document are for illustration purposes only, and may differ from the actual
equipment.
Senstar Corporation’s Quality Management System is ISO 9001:2015 registered.
Compliance:
This equipment should be installed and operated such that the transmit antenna is 25 mm (1 in.) or more away from any person during the
device’s operation.
Canada
: Innovation, Science and Economic Development Canada Certification Number:
1454B-LM100 (Senstar LM100 luminaire)
CAN ICES-3B/NMB-3B
This device complies with Innovation, Science and Economic Development Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Ce dispositif est conforme aux normes CNR Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes : 1) le dispositif ne doit pas produire de brouillage
préjudiciable; et 2) il doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
USA
: FCC Identification Number: I5TLM100 (Senstar LM100 luminaire)
FCC Certification - This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Europe
:
This device complies with ETSI standard EN 300 440 for European operation.
The use of shielded cables is required for compliance.
