SEF 548.04, Руководство по эксплуатации

Страница: 159 / 166

Page 11.11
11.0 Accessories
Accessories 548.04 \ 03.2010 \
13. Feed the motor cable through the pull relief into the
soldering system.
14. Fix the connecting terminal (1) on the bottom plate
of the drawer.
15. Pull out the 2-pin connector X4 (2) of motor cable
WS16 from the mains supply board (3) .
For the following work please observe also the
information in the printed circuit diagram on the
previous page.
16. Connect the 2-pin connector of the provided link (4)
with the socket X4 on the mains supply board.
17. Connect the free ends of the provided link (4) with
the connecting terminal (1) .
18. Connect the ends of the motor cable (of the
terminal extension) (5) with the connecting terminal
(1) .
19. Remove the 2-pin plug from the motor cable
WS16 (6) and connect the now free ends with the
connecting terminal (1) parallel to the motor cable
of the conveyor extension.
20. Pass the cables parallel to the installed cable
harnesses and fi x them with the installed cable
clips.
21. Close the drawer and fi x it with the screws.
22. Mount the left cover plate again.
23. If requested fi x the outlet chute to the rear front end
cover of the conveyor extension.
24. Mount the rear front end cover together with the
outlet chute at the conveyor extension again.
25. Switch on the soldering system again.