Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 99 / 153

Bluetooth Installation & Operation 4009-9 Installation Manual
18-1
18. Bluetooth Installation & Operation
18.1. Prerequisites
To use a Bluetooth device, as described in the information below, the MINIMUM requirements are:
• You must have a Sea Tel Series 09 antenna with MK2 PCU , a Series 10 antenna or a Series 11 antenna.
•
The PCU on your antenna must have software ver 2.03 or later.
•
Antenna Control Unit software versions
• DAC-2202 must have software ver 6.08 or later.
•
DAC_2302 must have software ver 7.08 or later.
• CommIF must have software ver 1.15 or later.
•
Suitable computer and Operating system.
18.2. Installing the ADE Bluetooth Hardware
The IOGear serial Bluetooth is shown below; other manufacturer/models may be used.
1. Turn Tracking OFF at the ACU.
2. At the ADE, open the hatch in the base of
the radome.
3. Reach into the radome hatch to secure the
AC power at the breaker.
4. Rotate the antenna pedestal to access the
PCU.
5. Carefully enter into the radome hatch, far
enough to reach the PCU.
6. Attach the SERIAL Bluetooth dongle
(Receiver) to the MK2 PCU Service Port. If
the device has retaining screws, secure
them to prevent the device from vibrating
loose.
7. Carefully exit the radome hatch.
8. Reach into the radome hatch to turn AC
power ON at the breaker.
9. Allow the antenna to reinitialize.
10. Secure the radome hatch.
11. Retarget the satellite if desired.