Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 27 / 153

Installation 4009-9 Installation Manual
3-5
11. Allow enough service loop to terminate these
cables to the circuit breaker assembly and
connector bracket respectively (see cable
termination information below).
HINT: It may be easier to connect, or tie-wrap, the
coaxes and power cable temporarily.
12. Lower radome assembly into the mounting holes,
positioned with the BOW reference of the radome
as close to parallel with centerline of the ship as
possible (any variation from actual alignment can
be electrically calibrated if needed).
13. Using Loctite 271, install the four fender washers
and hex nuts (provided in the radome installation
kit), from the underside of the mounting surface,
to affix the radome to the mounting surface.
Tighten to torque spec.
14. Remove the clamp bar and Roxtec®
Multidiameter® blocks from their cable mounting
frame in the cable passage channel.
15. Remove the rubber bar from the top of the
Roxtec® Multidiameter® blocks.
16. Remove the Roxtec® Multidiameter® blocks from
the cable mounting frame.