Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 81 / 153

Setup – Other Parameters 4009-9 Installation Manual
14-1
14. Setup – Other Parameters
14.1. SETUP Parameter display and entry menus.
Press and hold BOTH the LEFT and the RIGHT arrow keys for 6 seconds to access to the
system setup parameters (at the EL TRIM selection).
Press BOTH the LEFT and the RIGHT
arrow keys momentarily to access to the SAVE NEW PARAMETERS parameter.
Access is only required after installation or repairs of your antenna system. These parameters
should only be changed by an authorized service technician.
CAUTION: Improper setting of these parameters will cause your system to not perform properly. Also refer to
the SETUP section of your Antenna manual.
14.2. 5V OFFSET (May not be in your software)
CCW 5v Polang servo position reference. Refer to your antenna manual.
To manually update, press the LEFT arrow key to bring the cursor up under the least significant character.
Continue to move the cursor until the desired character to be edited is underscored (selected). Use the UP or
DOWN arrow keys to increment or decrement the selected character.
Use the LEFT or RIGHT arrow key to move the cursor left or right to select other characters to modify. When you
are finished modifying press ENTER to execute the new value OR press NEXT to abort and exit setup mode.
14.3. 5V SCALE (May not be in your software)
90 degree 5V Polang servo motion scale factor.
To manually update, press the LEFT arrow key to bring the cursor up under the least significant character.
Continue to move the cursor until the desired character to be edited is underscored (selected). Use the UP or
DOWN arrow keys to increment or decrement the selected character.
Use the LEFT or RIGHT arrow key to move the cursor left or right to select other characters to modify. When you
are finished modifying press ENTER to execute the new value OR press NEXT to abort and exit setup mode.
14.4. REMOTE COMMAND
This parameter was used to issue diagnostic commands to the PCU, but is superseded by the use of DacRemP
diagnostic software that your dealer will use when necessary.
14.5. REMOTE MONITOR
This parameter was used to monitor the results of a diagnostic command which was sent to the PCU.
14.6. To Disable/Enable DishScan®
When running a beam pattern test, a programmed sweep for NOC/Satellite Operator, balancing the antenna or
motor diagnostics where you want the drives (AZ, EL & CL) not to be oscillating you will have to disable
DishScan®.
Select the DISHSCAN® parameter window on the ACU:
1. Press the RIGHT arrow, then press the UP arrow and last press the ENTER key to turn DishScan® mode
ON.
2. Press the RIGHT arrow, then press the DOWN arrow and last press the ENTER key to turn DishScan®
Mode OFF.
If you change this remote parameter, you must save the change using REMOTE PARAMETERS .