Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 33 / 153

Installation 4009-9 Installation Manual
3-11
2. To un-restrain the cross-level axis of the
antenna use a 7/16“ open end wrench to
loosen the nut on the top side of the locking
bar (either end of the bar).
3. Remove the bottom nut off of that
adjustable bumper.
4. Remove the adjustable bumper from the
locking bar.
5. Extract the locking bar from the underside
of the cross-level beam and retain these
parts for later re-use if it becomes necessary
to stow the antenna.
6. Verify that the antenna rotates (tilts left and
right from level) freely through its full cross-
level range of motion.
3.6. Installing the Below Decks Equipment.
3.6.1. General Cautions & Warnings
CAUTION - Electrical Shock Potentials exist on the Gyro Compass output lines.
Assure that the Gyro Compass output is turned OFF when handling and connecting
wiring to the Terminal Mounting Strip.
CAUTION - Allow only an authorized dealer to install or service the your Sea Tel
System components. Unauthorized installation or service can be dangerous and may
invalidate the warranty.
3.6.2. Preparing BDE Location
Prepare the Rack (or other location) for the ACU, Terminal Mounting Strip and base multiplexer panel.
Prepare the mounting locations for the other Below Decks Equipment throughout ship.