Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 100 / 153

4009-9 Installation Manual Bluetooth Installation & Operation
18-2
18.3. Installing the BDE Bluetooth Hardware
The IOGear USB Bluetooth is shown below; other manufacturer/models may be used.
1. At the below decks computer, or portable
laptop, insert the Bluetooth Transmitter
into an available USB port.
2. The computer should automatically detect
new hardware and setup the Bluetooth
connection. In case the Bluetooth
connection is not automatically detected
you should use the CD that is included with
each Bluetooth dongle. Install that
software if necessary.
3. Once the setup is completed, you should
be prompted to enter a password to
establish a link from Master (TX) to Slave
(dongle-RX).
4. The computer will automatically assign a
virtual port for the USB connection. If you
are unaware of which serial connection has
been assigned, open the Device Manager
and check com port assignments.
5. Identify the correct COM port for your
Bluetooth device.
6. Once COM port is selected, open a
compatible Sea Tel diagnostic program
(ProgTerm or DacRemP).
7. In the Sea Tel diagnostic program select
the appropriate COM port for the
Bluetooth (refer to help in ProgTerm or
DacRemP as appropriate).
8. You are now ready to communicate
wirelessly to your Sea Tel antenna system.