Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 102 / 153

4009-9 Installation Manual Bluetooth Installation & Operation
18-4
18.6. Removing the BDE Bluetooth Hardware
1. At the computer, remove the Bluetooth
Transmitter from the computer USB port.
2. Close the Sea Tel diagnostic programs
(ProgTerm or DacRemP) which were being
used.
3. You are now ready to return to normal
operation of your Sea Tel antenna system.
18.7. Installing Software via Bluetooth
Using the Bluetooth connection, you can update the MK2 PCU software and/or the DAC software.
NOTE: You can NOT use the Bluetooth connection to update software in the CommIF, SCPC Receiver, 400MHz
modems or the Motor Driver Enclosure (MDE). If you need to update software in any of these assemblies you
must install the software from a direct connection to the ACU.
1. With Bluetooth hardware installed and setup per the “Installing the ADE Bluetooth Hardware “and
“Installing the BDE Bluetooth Hardware “paragraphs above.
2. From the computer, open ProgTerm.
3. It is strongly recommended that you save a parameter dump of the ACU and PCU parameters.
4. Use ProgTerm to update ACU or MK2 PCU software as you normally would.
5. Verify that all of the system parameters are correct after the software upload.
6. Retarget desired satellite.
7. Verify normal operation of the ACU/PCU system (refer to Functional Testing) and of the satellite modem.
8. Return to normal operation.
18.8. Normal Operation Mode
1. Target and acquire the desired satellite at the ACU or from DacRemP.
2. Turn Tracking ON at the ACU or from DacRemP.
3. Return to normal operation.