Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 28 / 153

4009-9 Installation Manual Installation
3-6
17. Pass the coaxes and power cable through the cable
mounting frame.
HINT: Again, It may be easier to connect, or tie-wrap,
the coaxes and power cable temporarily.
18. Re-install the cable mounting frame onto cable
passage channel using the four screws and flat
washers that were removed in step 7 above. .
19. Peel layers out of the upper and lower Roxtec®
Multidiameter® blocks to provide an opening in
the block that is just smaller than the outer
diameter of the cable that will pass through it.
When compressed the block should provide
clamping force on the cable and prevent it from
moving in the block.
20. Two cables may be passed through each of the
Roxtec® Multidiameter® CM-20w40 blocks
provided.
21. If cables larger than 1.65cm/0.65in outer diameter
will be used, larger single-cable Roxtec®
Multidiameter CM-40 10-32 blocks are available to
allow three cables of up to3.25cm/1.28in diameter
to be used. The
rubber bar and the three double-
cable Roxtec® Multidiameter blocks will be
replaced by the three larger Roxtec®
Multidiameter blocks .
HINT: It may be helpful to put the clamp bar and rubber
bar in place (held loosely by one screw) to hold some of
the Roxtec® Multidiameter blocks in place while you
complete the others.
22. Re-install the clamp bar using the hardware
removed in step 14 above.
23. Remove the tag lines.
24. Remove the lifting sling.
25. Remove the four lifting eye nuts and re-install the
original perimeter bolt hardware (the eyes are
galvanized with bare thread that will rust if left
exposed to the weather). Save the lifting eye
hardware in case lifting of the ADE is required in
the future.