Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 49 / 153

Setup – Band Selection 4009-9 Installation Manual
7-1
7. Setup – Band Selection
To properly control the band selection of the LNB(s) mounted on the antenna, the TRACK DISP (Tracking Display)
parameter must be set correctly. Which value the TRACK DISP parameter is set to depends on the hardware configuration
of the antenna pedestal.
The xx09-17 and xx09-33 antenna pedestals come with the waveguide diplexer and LNB to provide the additional Co-Pol
RXIF output to the Cross-Pol/Co-Pol select coax switch (all of the systems come with the switch and coax installed, so you
can easily upgrade the antenna with the Co-Pol hardware).
The TRACK DISP parameter controls Tone, Voltage and Aux functions remotely on the antenna pedestal. Voltage and
Tone are used to select the desired band of dual-band, tri-band and quad-band LNBs. The Aux function controls the Cross-
Pol/Co-Pol select switch.
Sea Tel provides quad-band LNBs as a default LNBs on the 09 Series antennas; therefore, the default TRACK DISP
parameter for Cross-Pol only systems is 0170 and 0130 for 09 antennas with Cross-Pol AND Co-Pol LNBs.
7.1. Cross-Pol Only Dual-Band LNB
Use Xp 13 when you want Cross-Pol low band output to be routed to below decks or use Xp 18 to select Cross-Pol
high band.
TRACK DISP
Setting Displayed band
selection ADE Band Select Parameters
(Tone, Voltage & Aux Status)
0040 Xp 13
Xp 18
Cp 13
Cp 18 Tone OFF, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1