Sea Tel 4009-9 BROADBAND-AT-SEA, Руководство по установке

Страница: 101 / 153

Bluetooth Installation & Operation 4009-9 Installation Manual
18-3
18.4. Diagnostic Mode
If you are doing diagnostics and will NOT be using the system in normal operation, follow the instructions below.
If you WILL be operating normally, refer to the next section.
1. If you are diagnosing a problem (using DacRemP), use the desired diagnostic recording module(s).
2. Issue other commands as desired.
3. If ON satellite testing is to be done, target and acquire the desired satellite at the antenna control unit, or
from DacRemP.
4. If tracking is required, turn Tracking ON at the antenna control unit, or from DacRemP.
5. If the Bluetooth hardware is not to remain installed, refer to the sections below to remove the hardware
from ADE & BDE, before returning to normal operation.
6. When use of diagnostic mode is completed, refer to Operation mode.
18.5. Removing the ADE Bluetooth Hardware
1. Turn Tracking OFF at the ACU.
2. At the ADE, open the hatch in the base of
the radome.
3. Reach into the radome hatch to secure the
AC power at the breaker.
4. Rotate the antenna pedestal to access the
PCU.
5. Carefully enter into the radome hatch, far
enough to reach the PCU.
6. Remove the SERIAL Bluetooth dongle
(Receiver) to the MK2 PCU Service Port. If
the devices retaining screws were secured,
unscrew them to remove the device from
the PCU.
7. Carefully exit the radome hatch.
8. Reach into the radome hatch to turn AC
power ON at the breaker.
9. Allow the antenna to reinitialize.
10. Secure the radome hatch.
11. Retarget the satellite if desired.
12. Return to normal operation