Light Source Operation
D20980.022 Rev C
CV-LS User Manual
Page 47
Single-Color Control Example
One common use of the RGBW unit is a single color light source, where the user only needs a single
color at a time, but may need to change between colors. Use the following sequence to achieve this
type of operation:
1.
Press and hold the button for more than ten seconds. The LED ring light will be blinking once per
second.
2.
Release the button to return to factory defaults.
3.
Default settings will put the common channel at 100% and the knob will control channel 1 (Red).
4.
Press and hold the button for two seconds. The LED ring light will start blinking ten times per
second.
5.
Once the LED ring light is blinking ten times per second, turn the knob to the desired channel.
See the available modes above, IE 40% position for Green.
6.
Release the button before six seconds has elapsed. This will change the channel and the
corresponding color will turn on.
Note: If the button was held for more than six seconds, the
LED ring light will start blinking two times per second. Releasing the button at this time will
only save the current settings, not change the channel.
7.
At this point, the unit will act as a single channel light source of the selected color.
8.
You can press and hold the button for six seconds (the LED ring light will be flashing two times
per second), then release to store this operating mode.
9.
To change to a different color unit, turn the knob to 0% to disable the current channel.
10.
Follow steps 4 through 7 to select a new channel.
Multi-Color Control Example
A second common use would be to set a color mix using multiple channels, then dimming the pre-mixed
color. Use the following sequence to achieve this type of operation:
1.
Follow the instructions to set up the unit for a single color.
2.
Set the knob at the intensity for that color to mix with another.
3.
Follow steps 4 through 7 of the Single-Color Control Example section above to select a new
channel (the first channel should still be active at the intensity you last set).
4.
Repeat for as many channels as you would like to mix.
5.
Once the target color mix is achieved, set the unit back to the common channel (0% point of the
knob) to dim the color with the knob.
Содержание ColdVision
Страница 36: ...D20980 022 Rev C CV LS User Manual Page 36 LED LED UV UV LED RMA 91...
Страница 38: ...D20980 022 Rev C CV LS User Manual Page 38 1 SCHOTT SCHOTT machine vision moritex com...
Страница 42: ...D20980 022 Rev C CV LS User Manual Page 42 LED LED UV UV LED Return Material Authorization RMA 91...
Страница 44: ...D20980 022 Rev C CV LS User Manual Page 44 SCHOTT SCHOTT machine vision moritex com...
