Product Specification
D20980.022 Rev C
CV-LS User Manual
Page 86
Rear Panel Description
The back of the unit is where power is supplied, all remote control interfaces are connected, and the air
intake vents for LED cooling are located. All ports on the back of this unit are locking connectors for
industrial use.
CAUTION
The vent slots on the rear panel supply air to cool the LED. Insure adequate air flow to vents at all times.
Figure 30: CV-LS Rear Panel Description
Label
Description
Vent Inputs
Air is pulled into these vents to cool the LED.
DC Power Input
The included AC/DC power supply will plug into this locking connector.
Ethernet Dual 10/100
Switch
The dual Ethernet port is a built in 10/100 Ethernet Switch. Either port can be
used to connect the unit to a network. The second port can be used to chain
units off the same network port.
USB Virtual RS232
This port will be detected as a RS232 port and can be used in any software
that would normally connect to RS232. (See the
Error! Reference source not
found.
section on page 94)
Multiport Top Port
This connector contains CH 2 to CH 4 analog and digital inputs, as well as the
native RS232 TX and RX pins.
Multiport Bottom Port
This connector contains CH 1 analog and digital inputs, fault output, DC power
input, 5V output, and GND connections.
Multiport
Top Port
Vent Inputs
USB Virtual
RS232
Ethernet Dual
10/100 Switch
DC Power
Input
Multiport
Bottom Port
Содержание ColdVision
Страница 36: ...D20980 022 Rev C CV LS User Manual Page 36 LED LED UV UV LED RMA 91...
Страница 38: ...D20980 022 Rev C CV LS User Manual Page 38 1 SCHOTT SCHOTT machine vision moritex com...
Страница 42: ...D20980 022 Rev C CV LS User Manual Page 42 LED LED UV UV LED Return Material Authorization RMA 91...
Страница 44: ...D20980 022 Rev C CV LS User Manual Page 44 SCHOTT SCHOTT machine vision moritex com...