SCHOTT ColdVision, Руководство пользователя

Страница: 65 / 94

CV-LS Dashboard
D20980.022 Rev C CV-LS User Manual Page 65
Control Name Description
Triggered Strobe Options: Enable, Disable
When this option, along with the Output Power, is enabled, the LED will
strobe at the settings listed below.
Combined Trigger Options: Enable, Disable
When this option is enabled, the system will trigger a strobe on all channels
when there is a signal on any of the four multi-port digital inputs.
Channel Operation Options: Single, Quad
All four channels strobe with the settings of Channel 1 when in Single mode.
Quad mode shows settings for each channel individually.
Channels Options: 1, 2, 3, 4, All
When in Quad mode, all options are displayed to allow the user to show
different channel settings. If ALL is selected, then all four channel settings are
displayed at once.
Note: The following settings, denoted by Ch X, are the same for all four
channels.
Ch X Delay Slider and
Numeric Up Down Range: 0 – 1000000
µ
s
Number of microseconds the channel will delay, from when the trigger signal
is received, before turning on the LED.
Note: This setting is in increments of 5
µ
s. You can set a value in increments of
1
µ
s for Legacy Command response, but the system will round down to the
nearest 5
µ
s increment.
Note: There is a 4 – 9
µ
s delay in the response time of the system. This setting
adds to that time.
Ch X On Time Slider
and Numeric Up Down Range: 25 – 1000000
µ
s
Number of microseconds the channel will remain on for the strobe pulse.
Note: This setting is in increments of 5
µ
s. You can set a value in increments of
1
µ
s for legacy command response, but the system will round down to the
nearest 5
µ
s increment.
Ch X Trigger On Options: Falling Edge, Rising Edge
Channel will trigger on the falling or rising edge of the input signal, on the
digital pin of the multiport, depending on this setting.