collected data.
Note: The throttle must be connected BEFORE of start the test.
Note: If the TPS relation is not recognized the “Search” mode do not
will work.
Report on screen
After perform the test, the tester will have enough information to show
a result on screen.
Press “OK” key, and the report will appear. Use + and – to change the
parameters showed, and OK when you has seen everything.
TYPE
: Used formula to check the consistency of TPS of throttle or
pedal used. Are 4 possible data:"
T1&2=100
", "
T1=T2x2
", "
Toyota
".
"
Unknown
" mean that cannot be recognized the relationship,
probably because a bad connection, critical failure of throttle or a new
and unknown body for the HMP1.
TPS1
: Report OF integrity of TPS1 with the following data.
A=Tps1
C=Continuity
B=Minimum registered
D=Maximum registered
The device make 2000 read by
seconds to the TPS, the continuity is
the most greater jump between 2
consecutive measures, the objective
is try to discover any damage in the
track of sensor.
TPS2
: Same as TPS1.
Maximum Difference:
The TPS1 and TPS2 have a relationship
(different according the car). The difference is the error between ideal
relationship and the really measured in both sensors. The HMP1
monitor permanently this difference and record What was the
7/36
