NOTE: This output supports very very low consumption, therefore it
simulates sensors and cannot be used to power devices.
5V and 12V Pulses Generation
This pulses allow generate 5v pulses between 3Hz and 5700Hz
(1Hz=1 pulse by second), the utility is to perform general
testings. Simulate a frequency based MAP, ABS sensors (is
possible that require extra signal conditioning) Smart
alternators based on 5v or 12v pulses.
The 5v pulses out from TPS1 pin and
the 12v pulses out for pin COIL+.
Note that the pulses are for small signals and
cant be used for coils/solenoids/valves. In
addition to not working, it can burn the
device and the coils, etc.
With the + and - keys the frequency go up or down,
leaving the key pressed, the movement will be more faster.
Press OK when the test are done.
Injector testing with flash
This function allows testing up to 8 injectors in a bench
operation. This means that first open the 4 injectors of bank
A
open and then the 4 injectors of bank
B
. The injectors opening
time is configurable between 2 and 14mS, The RPM are
configurable RPM between 1000 and 4000. The system has a
Timer, which allows you to work continuously or for a specific
number of minutes. (0 ~ 7min)
27/36
