Sargent 2600 Series, Инструкция по установке

Страница: 15 / 36

14
DETAILED PROGRAMMING
INITIAL SET UP AND PROGRAMMING
Introduction: Each opening may have individual setting requirements determined by the required function, door
size and location and compliance issues. For compliance questions, consult with ANSI requirements or inquire with
your local jurisdiction. For special applications or other assistance, consult the factory at 800-810-9473.
Programming With the Control Unit
To access the Control Unit, remove the Operator cover.
Display & Program Buttons
In above view, when you press any of the three program buttons, the left display shows the status of the function
switch:
0 = Manual: The door is opened manually, and closed under power.
1 = Auto: The door is opened and closed under power.
2 = Hold Open: The door is held indefinitely at the fully open position.
DIRECT CURRENT - MOTOR
PULSE DISK
PULSE COUNTER
FIRE ADAPTER
SAFETY CLUTCH
AND GEAR ASSEMBLY
PROGRAM BUTTONS
CONTROL UNIT
SAFETY SENSOR
LOCKING CIRCUIT
IMPULSE OUTSIDE
IMPULSE INSIDE
SIGNAL DOT
IMPULSE OUTSIDE INHIBIT
PROGRAM SELECTOR PULSE DISPLAY
STATUS
RED: ERROR
YELLOW: ADJUSTMENT
GREEN: OK
(SIDE VIEW SAFETY CLUTCH AND
GEAR ASSEMBLY)