180AP Quick Setup Guide
Please read and understand Section 1 safety, Section 3 Installation & Adjustment and Section 4
Operation in the owner’s manual that came with your 180AP.
180AP TIG Setup
•
Gas Purge – Pressing this button turns on the gas solenoid. Pressing the Gas Purge button again
shuts off the gas solenoid.
•
HF Start - For HF non-contact arc starting Press the HF Start button. The yellow light illuminates.
o
For Lift TIG contact arc starting HF light is OFF.
•
Pulse – To select Pulse TIG mode Press the Pulse button. Yellow light will illuminate.
o
Pulse parameters are Iw, Ib, Dcy, Fp.
Iw – Peak current
Ib – Background Current
Dcy – Ratio of time spent at peak pulse. If set at 50%, then 50% of each cycle
will be at peak current.
Fp – Pulse Frequency in Cycles Per Second.
