Sargent 2600 Series, Инструкция по установке

Страница: 24 / 36

23
Control Value Factory
Point Description Range Setting Comments
Number
16 Door hold open time: 0 – 60 8.0 The time period for which the door will be held
Push and Go sec at the fully open position when the Push and Go
feature is active (Control Point 13 is set to 1).
• For a typical Push and Go application, the door
opening time should be 10 sec.
17 Door hold open time: 0 – 60 15 The time period for which the door will be held
Delayed impulse sec at the fully open position when a delayed impulse is
received by the Operator.
• For a typical push-plate application, the door
opening time should be 15 sec.
18 Operation of latching 1 or 0 0 A latching device can be controlled by the Operator.
device relay on/off 0= In Auto mode, when the Operator receives an
impulse, the latching device relay is activated and
the latching device is energized.
1= In Auto mode, when the Operator receives an
impulse, the latching device relay is not activated
and the latching device is not energized.
19 Stall feature 1 or 0 0 Selection of obstruction sensitivity feature operation
(Closing Direction) on/off in closing direction.
0= The door stops and does not move.
1= The door stops, then reopens to the fully
open position.
• See Control Point 12.
20 Hold-open force 0 – 10 0 While the door is fully open, the Operator holds it
relative against the door stop to prevent the door from
moving, for example because of wind pressure.
0 = No force
10 = Maximum force
• Specify this setting after the fully open position
Wind Condition has been established. See Control Point 01.
21 Latching device unload 0 – 10 0 While the door is in the fully closed position and
force relative receives an “open” impulse, the Operator forces the
door against the frame stop for 1 sec, making it
easier for the latch to release.
0 = No force
10 = Maximum force
22 Latching device relay 1 – 10 2 This setting controls the length of time that the
hold time sec lock control relay is activated.
• In a fire door application, the latching device
relay hold time should be set to the minimum.
• Used for latch retraction devices or electric
strikes.
CONTROL POINTS