32
You can program the Door Operator in either of two ways, using the optional remote programmer or the Control
Unit on the Operator.
Programming With the
Hand Held Programmer
•
Hold the remote programmer within 18 inches of the red
LED on the Door Operator and point the remote programmer
at the LED.
•
Aim the programmer towards the “Power Switch” end of the
function switch.
To program the Operator using
the Hand Held Programmer
1. Verify that the Operator power switch is set to “ON”.
2. Set the remote control power switch to “ON”.
Note: Four zero’s will be displayed with the first digit
blinking.
3. Aim programmer toward the “Power Switch” end of
the Door Operator and press “OK.” at the LED. The
hand held programmer will display information about
Control Point 0.
• First two digits: 00, the identifier of the Control Point.
• Second two digits: the current value of
Control Point 00.
4. Use the lower - and + signs to change the value.
5. When the correct value is displayed, press OK to
store the value.
6. Use the upper + sign to display Control Point 01.
7. Use the upper - and + signs to select a Control Point.
8. Use the lower - and + signs to specify the desired
value for the Control Point.
9. Press OK to store the value.
CONTROL VALUES
9V BATTERY
(LITHIUM OR ALKALINE)
TRANSMITTER
DECREASE
POWER SWITCH
4-DIGIT
DISPLAY
CHANGE
CONTROL POINT
SET VALUE
RESET ERROR
INCREASE
AIM
TO THE LED
LED
HAND HELD PROGRAMMER (optional)
Содержание 2600 Series
Страница 29: ...28 ELECTRICAL WIRING Typical Application 1 ...
Страница 30: ...29 ELECTRICAL WIRING Typical Application 2 ...
Страница 31: ...30 ELECTRICAL WIRING Typical Application 3 ...
Страница 32: ...31 ELECTRICAL WIRING Typical Application 4 ...