SANKI MAGDRIVE CLAM, Руководство по эксплуатации и обслуживанию

Страница: 21 / 28

21
When replacing broken/defective magnet of line shaft, parts which need to be removed (other magnets,
shaft end collar, shaft couplings, etc.) depend on position of broken/defective magnet. For proper
replacement of magnet, refer to the following procedures.
1. Referring to diagrams on p.20, remove top cover(*1), upper bearing holder(*2) and all the carrying
rollers(*3).
NOTE: For carrying roller removal, see p.16.
2. Remove bearing upper covers(*12) and line shaft(*10) from conveyor main body. Then remove shaft
coupling(*11) and shaft end collar(*15).
3. Pull broken/defective magnet (*9) out of line shaft(*10). If broken/defective magnet is attached
between 2 bearings, replacement will be easier by removing the bearing(*13) closer to broken
/defective magnet.
NOTE: When removing magnet, be careful not to allow it to touch other magnets.
4. Position replacement magnet (*9) at the O-ring(*6) of removed broken/defective magnet on line
shaft(*10).
NOTE: Fit center of magnet(*9) to center of O-ring(*6). If O-ring is broken/defective, replace it as well.
5. To restore line shaft, correctly reinstall removed parts(magnet, collar, etc.) in initial positions in reverse
order. (Do not make any gap between magnet and collar(*16). Incorrect magnet positioning may cause
a machine operation malfunction.)
6. Reinstall shaft coupling(*11) and shaft end collar(*15) to line shaft(*10).
7. Reinstall line shaft(*10) to conveyor main body, and reinstall bearing upper covers(*12) to bearing
brackets(*14).
8. Reinstall all the carrying rollers removed in step 1 above in initial positions.
NOTE: Make sure that there is a minute clearance between carrying roller magnet(*5) and line shaft
side magnet(*9). Check each part again if there is any trouble.
9. Reinstall upper bearing holder(*2) and top cover(*1). (Refer to diagrams on p.20.)
10. Run conveyor to check if carrying roller(*3) rotates correctly. Check each part again if there is any
trouble.
7-2. REPLACING MAGNET OF LINE SHAFT