SANKI MAGDRIVE CLAM, Руководство по эксплуатации и обслуживанию

Страница: 10 / 28

10
4
RUNNING THE CONVEYOR
4-2. STARTING CONVEYOR
1. Constant-speed Type (100/200 V single-phase)
Push illuminating- start switch into “RUN” position. To stop machine,
push it to “STOP” position.
NOTE: This switch is not for turning power on and off. When leaving
conveyor unused for a long period, make sure that it is
unplugged or main switch is off.
2. Brushless-inverter Variable-speed Type
For brushless-inverter (inverter for brushless-motor variable-
speed control) variable-speed type, operate machine as follows:
NOTE: 1. Be sure to combine brushless inverter with specified
brushless motor.
2. Be sure to ground before use.
(1) Make sure RUN/STOP switch on brushless-inverter
operating panel is in “STOP” position. Turn on power
supply and ensure that power LED (power-on indicator) is
illuminated in green.
(2) Set RUN/STOP switch to “RUN” position. Motor will start
rotating and conveyor will run.
(3) To increase speed, turn speed control clockwise; to decrease
speed, turn it counterclockwise. Set appropriate speed for
intended use.
(4) To stop conveyor, set RUN/STOP switch to “STOP”
position.
4-1. BEFORE OPERATION
100V single-phase power source : Ground earth terminal (green) of power cable plug.
200V single-phase power source : Ground earth terminal (green) of power cable.
200V three-phase power source : For variable-speed type, ground earth terminal (green) of power cable.
For constant-speed type, machine does not have switch etc. Provide
an earth cable on motor or drive unit side plates when wiring.
AC 100V single-phase
Earth (green)
Power cable plug
●
Power cable and terminals
AC 200V single-phase
Earth (green sleeve)
Power (red sleeve)
Speed control
Alarm LED (red)
Power LED (green)
Rotation-direction
selecting switch
(CW/CCW)
RUN/STOP switch