SANKI MAGDRIVE CLAM, Руководство по эксплуатации и обслуживанию

Страница: 20 / 28

20
7
MAGNET REPLACEMENT
7-1. REPLACING MAGNET OF CARRYING ROLLER
1. Remove top cover(*1) and upper bearing holder(*2) attached over carrying roller(*3) with broken
/defective magnet(*5). Then remove carrying roller(*3) .
NOTE: For carrying roller removal, see p.16.
2. Pull magnet side bearing(*4) out of carrying roller(*3). Remove collar(*7) adjacent to the removed
bearing(*4).
3. Pull broken/defective magnet(*5) out of carrying roller(*3).
NOTE: In advance, remove dirt from broken/defective magnet(*5). When removing the magnet, be
careful not to allow it to touch other magnets.
4. Fit center of replacement magnet(*5) to center of O-ring(*6) on carrying roller shaft. If O-ring(*6) is
broken/defective, replace it also.
5. Reinstall collar(*7) and bearing(*4) in initial positions. Then set carrying roller(*3) to lower bearing
holders(*8).
NOTE: Make sure that there is a minute clearance between carrying roller magnet(*5) and line shaft
side magnet(*9). Check each part again if there is any trouble.
6. Make sure that both bearings(*4, *10) are correctly inserted in slots of lower bearing holders(*8). Then
reinstall upper bearing holder(*2) and top cover(*1) in initial positions with attachment bolts.
7. Run conveyor to check if carrying roller(*3) rotates correctly. Check each part again if there is any
trouble.