SANKI MAGDRIVE CLAM, Руководство по эксплуатации и обслуживанию

Страница: 22 / 28

22
8
TAKE-UP AND REPLACEMENT OF TIMING BELT
8-1. TAKING UP TIMING BELT
If line shaft does not rotate while motor is running, it is possible that timing belt is slackened off. In this
case, take up belt slack as follows:
1. Remove drive unit cover(*1) by loosening cover attachment bolts(*2).
2. To take up timing belt(*5), loosen attachment bolts(*3, 4 bolts) and move geared motor(*4) slightly
downward.
3. Properly adjust timing belt tension. Fix geared motor(*4) by tightening attachment bolts(*3, 4 bolts).
4. Reinstall drive unit cover in initial position with cover attachment bolts(*2).
5. Run conveyor to check if line shaft(*6) rotates correctly. Check each part again if there is any trouble.
NOTE: Do not take up timing belt too much. Excessive belt take-up may overload motor or shorten service
lives of timing belt and timing pulley.