Sanden SN3500, Руководство по установке

Страница: 15 / 150

General Information
82005-IM-K Sandel SN3500 Installation Manual Page 1-7
The bearing pointers can derive their information from any of the connected
navigation receivers, including two composite NAV inputs, ADF’s, TACAN’s, and the
long range navigation receivers through the serial ports.
ADF’s can be connected as ARINC 407 synchro or DC SIN/COS inputs. See the
installation drawings for interconnection data and select the appropriate format from
the ADF maintenance page.
The composite NAV inputs accept standard 0.5v ARINC inputs. For 3v inputs a
series resistor is required, please see the appropriate installation drawing. Selection
of 0/180 phase is made by the appropriate maintenance page calibration.
1.4.9 ARINC Channels
The SN3500 contains universal inputs capable of communicating with ARINC 429,
ARINC 419, RS232 and Analog. All equipment capable of ARINC compatibility (such
as GPS/FMS, Navigation, Traffic, etc) can be directly connected to the appropriate
signal input. There are a total of 17 compatible ARINC inputs.
1.4.10 DME Interface
DME inputs support ARINC 429, ARINC 568, King serial, or analog (40mV/mile)
inputs. Analog DME is supported only in software versions 2.01 or higher.
1.4.11 Special Considerations for GARMIN GNS430/530 Series
Required SN3500 Setup Items
Maintenance
Page Items Study the Sandel Maintenance Page Items on the appropriate GNS430
installation drawings, and set as indicated.
Relay Mode MASTER
ILS Lockout OFF
Required GARMIN GNS430 Setup Items, Receiver 1
Software Main 1.00 or later
IN 1: Low, Sandel SN3500
OUT: Low, GAMA 429 Grph w/Int Note: NOT ARINC 429!
Main ARINC 429
Configuration
SDI: LNAV1 SDI1
Speed RX: Low
Speed TX: Low
VOR/LOC/GS
ARINC 429
Configuration
SDI: VOR/ILS 1 SDI1
Required GARMIN GNS430 Setup Items, Receiver 2